Valve Shim Calculator

Calculate a replacement valve shim from your measured clearance and the clearance range in your engine's service manual. Works for direct acting shim over bucket and shim under bucket setups with a 1:1 shim to clearance change.

Measuring several valves? Use the multi-valve worksheet below.

Before you start: Get the correct intake or exhaust specification for your exact engine and measure the old shim with a micrometer. Check the manual's engine temperature and measurement procedure. This calculator does not select a vehicle specification or shim diameter for you.

Enter your measurements

Shims are sized in millimeters, even if your clearance spec is in inches.
Choose the interval offered by your shim supplier. Verify the actual sizes available.

How the valve shim calculator works

New shim = current shim + (measured clearance − desired clearance). A thicker shim reduces the gap; a thinner shim increases it. The calculator aims for the middle of the range you enter, then checks whether an available increment will keep the predicted clearance within the full range.

Example: with a 2.40 mm shim, 0.28 mm measured clearance, and a 0.15–0.20 mm specification, the midpoint is 0.175 mm. The exact calculated shim is 2.505 mm. A 2.50 mm shim would predict 0.18 mm clearance if that size is available.

  1. Use the specification for the exact vehicle, engine, valve, and measuring temperature.
  2. Measure the clearance and existing shim thickness. If no feeler gauge fits, the actual clearance is unknown; follow your manual's procedure instead of entering zero.
  3. Install a shim of the correct diameter and thickness, then recheck the clearance. Do not use this 1:1 formula for rocker arm or other arrangements where shim thickness and valve clearance do not change equally.

Valve Shim Worksheet

Record every intake and exhaust valve in one place. Add or remove valves to match your engine, including a three-intake, two-exhaust setup. The worksheet calculates a shim for each valve and makes a short replacement list.

Use your service manual. Enter the clearance range for your exact engine and measurement temperature. The optional example uses fictional values, not specifications for any ATV or motorcycle. Verify every finished clearance.

Job setup

Current and replacement shim thicknesses are always shown in millimeters.

Clearance range from your manual (mm)

Intake valves

Intake 1

Intake 2

Exhaust valves

Exhaust 1

Exhaust 2

Shim list

0 replacement shims

Enter measurements to build a shim list. Confirm shim diameter and available thicknesses before installation.

  • No replacement shims listed yet.

Formula: new shim = current shim + (measured clearance − target clearance). This is for direct acting shim over bucket or shim under bucket designs with a 1:1 change. A zero or unmeasurable gap needs the service manual procedure. Measurements stay in this browser; printing is optional.